kounelosNickem
I am just starting to develop Firmware 3.1 because Firmware 3 could not be found. I'll inform you later where to get this driver. God Bless

DevilFs
Thanks a lot your good.

Devastator82
Bluescreened me as well...dont use

Globalhawk
It didnt work on my system. but stable anyway.

tallman
creathfinhjm

wolfshadow
this is vinayak. i have a little bit problem about my display driverbecause when i switch to 1024 by 768 pixels my computer slows down and runs frame by frame.do you have any idea about it. if yes then pleasemail me to manglekarvgyahoo.com

Cruckie
Super driver. Kome treba neka ga si skine.

morochobv
nada

Julian
finally it worx WOOHOOOSHIBBY

ravennl
thank you it works percfect

DarkArchangel
este drive estava me fazendo falta e estive procurando pelo mesmo ha um bom tempo. Obrigado.

rsnbahia
good

Rhadamenthys
The driver didnt create two separated components like Intel USB 2.0 Enhanced Host Controller and USB 2.0 Root Hub Device but it created one Intel 82801DBDBM USB2 Enhanced Host Controller and it works correctly

Egregious
Could not get it to fully load from dos

aclimmon
Es un buen driver graciasvery goodsl2

c0d3rAllasar
Thankyou very much. The drivers worked fine

skzi
muy bueno

leyendas
Cool This is a link and a driver that works Thanx

Fatality
I downloaded the driver did the installation which went as smooth as you could want and it was immediately recognized by my XPPro system.When coupled with the DSL it did it's Job marvelously.I would definitely recommend this one it seem to cover all the bases in record time and when I uninstalled it I just went to my AddRemove area and it came out no problems.This is definitely a good one.Thank you to whomever Uploaded this little Gem.RegardsAaron

yeti25
Thank you very much I have been looking for this for days

yyahmee
In need for W2K drivers for capture card CP848

quyen00
Actually it's not what I needed.

caribu66
difficult to find. WORKS GREAT

Ranny
worked fine