phoenix
waste of time TT

luckasgrilo
Excelent

Fabian
Only worked after I copied it to my hard disk and it asked for Win 98SE CD during installation. However it's a very good driver.

CrazyKolle
Jus dwnld'd this after wreckin original cd full of drivers works fine

daodum
ok

Moon
Para mi es uno de los lugares mejores que hay en la internet para uno conseguir los drivers que necesita.gracias por todo y que sigan mejorando.

criat
The driver is working well in my old packard bell. thanks for posting it.

ForNowImNothing
Don't bother drive doesn't even download

clems313
not bad it works finethanx

hivana
Youll only need this if your using service pack 3 or earlier. This driver is not needed for Windows 2000. After installing SP4 uninstall the USB controller and reboot

bogdy15
Good

Yokaii Spirit
Y need the driver for a USR 3CP265699A modem work this driver what a specified modem

diabolo1
Great to watch it go in and then hear sound.I give it a 9

Steel
Works great Thanks

iceglen
Se los recomiendo si me sirvio

HIKER
The zip folder came up with corrupt. therefore I could not use or try

mauro57
Valeuuuu EricoFuncionou legal agora vou poder trocar meu Lentium 166 por um K6II 500 e ainda por cima com msica.

seballero
thanks guys you never fail me...

AlexTheCorfiot
Thank youYou are my last chance

ElgarL
the driver don't work i dont know why

neogeo
Worked well

Majell
I could not down loan this drive from your site.

citruz
Driver worked amesome first time. 3com doesn't even have this driver listed anymore.Thanks again

jliao2005
.exe unable to extract files

rage
Didn't work with my card which I think was us

MuRKa
seems to work fine so far use on an IBM LG Electronics Never said Goldstar but found it with the CDR8322B designation. I did have to make a dummy autoexec.bat for it to edit. then I reinstalled it and used it to install windows

rveniel
i've had this scanner for a while and could not get it work on my XP. the disk that came with it only suports up to WIN.2000. hope it work and a big thank you if it does.

godson
i cant dowload them i don't know why i receive an red message WARNING DOWNLOAD AND USE THIS FILE AT YOUR OWN RISK DriverGuide.com has not tested this file. DriverGuide.com assumes no responsibility for personal or property damage associated with using this file. We recommend that you check this file for viruses before using. Please immediately report any incorrect drivers or information to us immediately.Contacting download site... please wait.If your download does not start click here. so I cant dowlnoad it help me please

Kane Hart
MFC3100C FOR XP AND WINDOWS ONN IBMPC NEEDS TO BE DOUBLE CHECKEDAll printers must have direct dial tone for wall to direct fax sendreceive capabilities

Banana0
Works Well with system installed to...

llbobll
no funcion en mi xp pero no decia que lo era.

IiIKARLAIiI
This driver is not the correct driver for the card listed. The card listed LB1200U is an isa card not an pci card.also works with 98se

Maraxer
OK.Thank you very much.

pchost
TIP for P6SETML motherboards If the DAVICOM chip is not being recognized even with the CMOS setting for it enabled please note that THE DOCUMENTATION IS BACKWARDS as of April 23 2001 in the published jumper settings for this motherboard. JUMPER JP6 located directly below the DAVICOM 9102F chip needs pins 2 and 3 connected to be enabled NOT pins 1 and 2 as published.

AzzurroRosa
Valeu Me quebraram um galho...rs

Rlebana
Its working fine